On-chip Interconnect

On-chip interconnect today is based on copper/low-k wiring – in today’s chips, there can be more than 100 km of copper wires.

TSMC’s leading edge technologies use a novel copper gap-fill solution to enable the fabrication of smaller conductor lines. Newly-developed materials and processes allow significant reduction in line and via resistance to improve chip performance. A comprehensive suite of innovations on integration scheme, low-k material, and low-k process with selective deposition further enhance both performance (through capacitance reduction) and reliability. Beyond copper interconnect, explorations of single metallic elements, binary and ternary alloys, and 2D materials for future interconnect materials are underway both within TSMC and with our academic partners.

  • Electromigration reliability of dual damascene Cu/CVD SiOC interconnects

    2001
    Electromigration (EM) characteristics were evaluated for multilevel copper test structures embedded in a CVD SiOC low k inter-metal dielectric. After electromigration stress testing, Cu extrusion along the interface between SiOC and the SiN dielectric diffusion barrier was revealed as the primary cause of EM failure. No evidence of cracking or mechanical weak points was observed in the bulk SiOC film; thus improved EM lifetime is expected from enhancement in the adhesion strength of SiN to SiOC. The calculated EM activation energies for 0.35 /spl mu/m via chains and 0.5 /spl mu/m via chains are 0.82 eV and 0.93 eV, respectively. The current density exponent (n) was measured to be about 1, which is consistent with the void growth mechanism in Cu. The critical length was found to decrease with increasing current density, and the j/spl middot/L/sub c/ product was determined to be approximately 7500 A/cm. authors: M.H. Tsai, R. Augur, V. Blaschke, R.H. Havemann, E.T. Ogawa, P.S. Ho, W.K. Yeh, S.L. Shue, C.H. Yu, M.S. Liang